0
How do you change a outer boot on a CV shaft on a 2004 suzuki eiger ATV?
Wiki User
∙ 11y ago
Remove the tyre, remove the axle nut, pull the hub out, undo the top and bottom ball joint and steering arm. You will not be able to free shaft. Cv will pull straight out of the diff (may need bit of a tug), once shaft is out, pull teh rubber boot back and use a hammer to hit the outer cv off, will need a reasonable hit. You will not be able to remove old boot and fit the new one. Now reverse process to out back together
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you change a abs ring on the drive shaft?
It's part of the driveshaft outer cv joint. Replace the shaft as per 2002 Clio 1.5dci
How do you change the outer drive shaft boot on a Skoda Felicia?
A link to the manual describing the process is in related links.
How do you replace a rear Universial JOINT on 1987 suzuki samurai?
like any other one take the drive shaft off and change it
What is the outer layer of the hair shaft called?
The outer layer is the cuticle.
Is a 1985 suzuki 250 quadrunner shaft or chain drive?
Chain
Suzuki DT 25 long shaft weight?
Dry weight on a 1994 Suzuki DT 25 is 141 lbs.
How do you change steering shaft in 1990 Jeep wrangler?
How do you change the steering shaft in a 1990 Jeep Wrangler?
How do you change a belt on a Suzuki vinson?
you have to take the primary clutch off and start the belt on the secondary and use the sleeve on the primary to walk the belt on the primary shaft. Then reassemble the clutch and tighten down the nut. simple..
1983 suzuki GS 850 G a two or four stroke?
The 1983 Suzuki GS850G is a four stroke, four piston engine. Final drive is a shaft drive.
How to change a Tie rod on a 1993 Pontiac?
what kind of Pontiac ?front wheel drive? The outer unscrew, there is a knoch on the shaft comming out of the rack. inner is a little harder you need a special socket.
Can i change the shaft on my Nike Sasquatch Machspeed driver if so how?
you can change it but you have to get either a shaft that already is compatible with the str8-fit or someone to install the shaft into the str8-fit ending.
What are the advantages of using a hollow shaft in a power transmission system over a solid shaft?
Most of the force in a shaft is carried by the outer layers of the shaft, and very. very little by the center. By using a hollow shaft you get almost the same turning strength for a lot less weight and material.
