0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Mondeo auto mk2 mpg?
Less than 20 mpg urban , and i have a light foot ....2l auto estate
Warning light on Ford Mondeo tdci 53 plate looks like a spring its flashing?
glow light change fuel filter
How do you change rear light bulb on a citroen c5 estate?
how do you change the rear light of a c5 citreon estate? I have reversed into somthing and the top half is bocken
How do you change the brake light bulb on a 2007 mondeo estate?
remove the break light by undoing to plastic nuts located on the back of break light, you must remove two covers to get at the nuts unscrew them and the unit will pull out. put new bulb in and put nuts back on tighten them back up making sure the unit is square and the job is done
What is the light on the dashboard of mondeo turbo looks like a watewr can?
oil light
How do you change dipped head light bulb in a Ford Mondeo mk2?
pull head light clip down remove connector from bulb depress retaining clip extract bulb
Where are mondeo brake light swiches?
Brake light switches are above the brake pedal
If you had enough corpses could you change a light bulb?
yes, but you need 59 and 1 quarter( getting the quarter is a bit messy)
How do you change a 2002 Ford Mondeo headlight bulb?
There are 2 metal tabs above the headlamp assembly. pull them out completely and disconnect the multi pin connection. the whole light unit comes out and you can change the bulb easily.
What is the dashboard light on mondeo zetec that resebles an engine?
That is the check engine light.That is the check engine light.
How do you replace a headlightbulb on a Ford Mondeo?
on my mondeo (05 tdci) if you lift the bonnet and undo the clips that hold the front grill in place then behind the head light there are 2 flat rods pull these out and the head light will come out
How do you change rear brake light bulb on 2001 Ford Mondeo estate?
In the back, directly behind the lights, the trim must be removed.( There will be some clips or screws holding the carpet or plastic in place). once removed you will see the back of the lights, then its just a case of removing the blown bulb and replace a new one and fitting back the trim......
