0
disconnect the wiring plug.disconnect the two pipes.unscrew the 2 monting bolts
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the location of the dryer receiver for 1994 Mazda 929?
The 1994 Mazda 929 dryer receiver is located on the firewall in the engine compartment. The dryer receiver will be on the passenger side of the firewall.
Where is the receiver dryer 2002 pathfinder?
The Receiver Dryer is on the driver's side of the condensor, behind the front bumper. It's the long, silver cannister.
Where do you add R 134A to a 2000 F250 pickup?
On the passenger side there is a port on the receiver/dryer. The receiver/dryer is located next to the pluming box under the hood.
Where is the high side and low side in a 93 Chevy cutlass sierra?
Find the receiver/dryer, it's the can with the rounded ends, near the firewall, drivers side. The low pressure port is near the receiver/dryer, between the receiver/dryer and the compressor. High side is between the compressor and the condenser. The condenser is the part that looks much like a radiator and sits in front of the radiator.
On an '88 VW Jetta fixing AC system was this system built without a receiver?
The receiver dryer is the can looking thing next to the evaporator.
Where is the AC pressure switch on a 1995 Firebird Formula?
Usually on or near the receiver/dryer.
Where do you find the recharge connector on a 1996 Ford Contour?
It is on or close to the receiver dryer. GoodluckJoe
Where is the low pressure port on a 1990 Buick Regal that HAS been 134a retrofitted according to sticker inside hood?
By the firewall, under the hood, passanger side. The receiver/dryer is about the size of a large tin can. The low pressure port is on the line that leads out of the receiver/dryer.
Where is the low side port to recharge the AC located on a 2005 Ford F150 4.6V8?
On the receiver/dryer.
Where do you add refridgerent to a 2003 s10?
The low pressure service port which should be located on the receiver/dryer.
How do you change an ignitor on whirlpool dryer?
get a schematic free for whirlpool gas dryer
Where is the ac vacuum check valve on a 2002 Jeep Wrangler?
Low pressure test ports are near the receiver/dryer on most vehicles. If you can't find it near the firewall, check between the receiver/dryer and the compressor. A few vehicles don't have a low pressure test port. In that case, the system is tested by pulling the low pressure sensor, jumping it and connecting the gauges directly to the receiver/dryer. But check the entire length of the low pressure line before you do that.
