To change a side light in a Hyundai Santa Fe, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the headlight assembly, then carefully detach the connector from the old bulb. Remove the old bulb by twisting it counterclockwise, and insert the new bulb, making sure it’s secure. Finally, reconnect the connector and test the light to ensure it’s functioning properly.
The brake light fuse is in the fuse panel below the dash on the left side of steering column.
To change the rear brake light on a 2007 Hyundai Santa Fe, first, open the rear hatch and locate the access panel on the interior side of the tail light assembly. Remove the panel by unscrewing the fasteners or pulling it off gently. Next, disconnect the electrical connector from the tail light assembly, then twist and remove the old bulb from its socket. Insert the new bulb, reconnect the electrical connector, and reattach the access panel to complete the process.
no
Open the hatch, there are 2 screws holding the entire light assembly on each side of the vehicle. Take the screws out and lift the assembly away from the car outwards, there is a post on the front end holding it onto the side of the car. Then just twist the brake light socket to the left and pull it out to get to the bulb.
It is in the side compartment of the cargo area.
The drivers side is always considered to be the left side of any vehicle.
Near the Driver Side Kick Panel
Something is broken, loose or worn out
Remove the 3 nuts from behind the light housing in the trunk. Gently work housing free. You only need to change the bulbs that are dead.
uncase, unscrew old bulb, screw in new bulb, put case back on
In a Hyundai Santa Fe, the side light fuse is typically located in the engine compartment fuse box or the interior fuse panel. To find the exact location, consult the vehicle's owner’s manual, which provides a detailed diagram of the fuse locations and their functions. If you're unsure, you can also check the labeling on the fuse box cover for guidance.
Should be located at the upper end of the brake pedal under dash area Check to see that one side has power at all times and the other side only gets power when switch is closed