Facing the door from the inside, there is plastic trim on the frame on the LEFT side of the window, take the trim off and there should be two (2) large cut out holes where you can see a stud with a nut on it. The nut should be 10mm socket, loosen the nuts all the way off and from the outside of car pull the window hinge frame straight out towards you. reverse the same to install new window and use Phillips scew driver to attach the right side window clamp (right side from the inside of car) and your done.
If it's the opening type, unscrew the latches and take it off.
It's held on by one screw in the hand hold.
Turn the key to the right.
Begin by removing the inside door panel of your 2001 Mercury Villager. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install your new window motor.
On a 2000 Mercury Villager : The washer fluid for the rear liftgate is supplied by the same reservoir as the windshield ( located in the engine compartment )
Just use a flat head screw driver to pry it off.
ow do I access window switch on a 99 mercury willager?
Cause the window motor is out
It prevents the power window switches other than the driver's from operating.
If it is electric it's switch is on the drivers door next to the switches for the front windows
If you don't have experience doing this I suggest you take it to a glass shop, or you could do more harm than good.
replace the window regulator.