Want this question answered?
NO, the clutch for the starter is internal. The clutch is on the gear that engages the starter gear.You have to remove left side engine case and remove flywheel to access starter clutch assembly.
How do you figure the starter is okay just by popping the clutch? Popping the clutch uses the driveline to turn the motor over. The starter is not involved at all.
The problem may be with your starter and not with the clutch.
You need speciality tools and take it to a dealership that can work on it cause you can snap the crank
Check for power at the clutch switch, then check for continuity through the switch with the clutch pedal depressed. If there is power and continuity, then the starter (or even ignition solenoid/starter relay) is the problem.
the starter on a 95 RX7 is on the flywheel which is just in front of the clutch, you will need to remove the bell housing around the clutch assembly to get at it however.
I know about the starter and ignition, but I click the ignition and then it clicks, then when I press and hold the starter it starts then immediatly stalls, I have tried it in neutral, in gear, with clutch, without clutch, with clutch and throttle.
your one way starter clutch is blown out. same problem happened to me and raptors are highly know to break starter clutches. just buy an extreme raptor starter clutch kit.
Starter is defective, or battery is weak.
There's a clutch on the starter that acts like a Bendix gear on a car. This clutch is stripped out on your bike. You'll need to pull the starter to replace it.
To change the clutch on a 1993 Honda Civic the car will need to the safely raised. Remove the starter, shift cables, wire harness, and other components found on the transmission. Unbolt the motor mount and mounting bolts for the transmission and safely lower it. Replace the clutch disk and throttle body.
no. it connects to the solenoid