answersLogoWhite
Oldsmobile Regency

How do you change a starter on a 1989 Oldsmobile Regency 98?

515253

Top Answer
User Avatar
Wiki User
2008-11-14 05:09:58
2008-11-14 05:09:58

disconect the battery jack up car take converter shield off 5 bolts then lossen 2 bolt holding starter diconect wires note them then reverse putting back in but note if there is shims

1

Related Questions

User Avatar

where would the spark plugs at on a Oldsmobile 1989 engine

User Avatar

The 1989 Oldsmobile Regency fuse box is located beneath the drivers side dashboard. The fuse box will be near the emergency brake release.

User Avatar

take off the right wheel and the cover wall and you wll see it

User Avatar

Where is the taillight fuse

User Avatar

my Oldsmobile has a short on fuse # 15 what does ctsy power mirror lock ltr all stand for

User Avatar

How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it

User Avatar

The 1989 Oldsmobile EGR valve is located on the top of the engine, near the back. It is quite simple to change.

User Avatar

starter on this car should be simple 12pt metric socket and wrench set range from 10mm- 19mm and a pair of jackstands or ramps

User Avatar

disconnet batt 1st then loosen screws to wireing and then loosen bolts to starter

User Avatar

Solenoids are commonly mounted on the side of the starter. Many are integral to the starter and are difficult, if not impossible, to change or repair. FriPilot

User Avatar

Disconnect the - battery cable Raise and support the vehicle Disconnect wiring harness ar top of starter Remove mounting bolts and drop starter

User Avatar

Remove wiring remove the 2 bolts holding the starter to the engine,remove the starter,you might want to remove the air filterhousing and inlet hose.

User Avatar

looking for the car code for a ninety eight 1989 oldsmobile

User Avatar

Why is the electric coolant fan in your 1989 Oldsmobile cutlass cierra not working?

User Avatar

Fuel filter on 1989 olds 98 is located under driver's side passenger door. Follow the fuel lines and you will see it.Careful replacing it as it could be under pressure-Wear safety glasses to avoid gas spraying in eyes.

User Avatar

Disconnect - battery terminal Raise and support vehicle Disconnect wiring at starter Remove 2 mounting bolts Drop starter

User Avatar

it is located by the frame next to your front tire. You can put your truck on ramps to get under there and change your starter.

User Avatar

The starter solenoid is located on the top of the starter.

User Avatar

The 1989 Oldsmobile was most definitly a front wheel drive vehicle.

User Avatar

It is attached to the starter itself.Toyo joe

User Avatar

The starter is on the lower passenger side of the engine.

User Avatar

Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.

User Avatar

attached to the side of the steering column bracket under the dash.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.