take off the right wheel and the cover wall and you wll see it
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
1. remove positive battery cable. 2. Remove the serpentine belt. 3. remove harmonic balancer. 4. remove timing cover. 5. remove wiring connector from c.p. senser. 6. remove c.p. senser. 7. reassemble in same order as disassembled.
take the serpentine belt off and then take the crank pulley off the balancer and then you will need a puller to get the balancer off the crank.
The harmonic balancer must be removed to change the sensor because the crank position triggering rings on the back of the balancer are entwined with the pick-up, Sorry
change car buy new one
have you tried a 6 point socket?
I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.
Remove the belt. Remove the bolt that attaches the harmonic balancer. Rent or purchase a harmonic balancer puller. Follow the Instructions with the puller and remove the old balancer. Install the new balancer making sure to line up the keyway, a little oil helps. Put the retaining bolt back in and tighten to manufacture specs.
where would the spark plugs at on a Oldsmobile 1989 engine
You can go to a local parts place and rent a chrysler harmonic balancer puller. I just did mine on a 2001 and it costed 75.00 and when I was done they gave me my money back. It is the only way to get it off.
i would like to know where the pvc valve is and how to change it on my 1990 olds 98 regency 3.8.
they make a harmonic balancer install/ remover....very simple with the right tool... more than likely any local parts store should have one on the shelf...they come with a decent diagram to help ya out