You need to take out the air filter housing and hose leading to the intake. Below the distributor cap, you should see your starter. Remove the battery terminals from your battery and then remove the starter from it's home. Replace with new starter and reconnect battery terminals. Replace air filter housing and hose, then fire it up. Worked like a dream.
you can find information on a starter of early miatas on: http://www.racecaddy.com/mx5/tech/starter-mx5.html They have location, causes of failure and how to change it
The 1992 Mazda B2200 will hold close to 17 gallons of gas. The 1992 Mazda B2200 is a four-cylinder vehicle.
disconnect neg.cable,then disconnect pos. cable from starter ,then other wire,then remove 2 bolts holding starter to engine.
About 1 hour.
same as the 1994
Starter is on passenger side of motor underneath intake bolted to trans bellhousing.
4 cylinder is 2.6 ,6 cylinder is 3.0It usually says 3.0 somewhere on the body if it is.
It probably is the key switch.
What solonoid?? If it is the starter solnoid, you have to take the starter off.
The firing order for the 6 cylinder engine Mazda MX-3 is 1 4 2 5 3 6.
Four cylinder it is on the rear of the engine. Six cylinder it is on the front of the engine.Four cylinder it is on the rear of the engine. Six cylinder it is on the front of the engine.
how do i change the starter on a 1997 olds 88 royale?