0
Should be located in a removable housing at the engine end of the upper radiator hose. Drain about 1 gallon of coolant from the radiator Remove this housing Make note how thermostat is installed Clean both surfaces Replace thermostat and gasket Replace housing Re-fill coolant slowly to prevent an air lock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change heater core in 1989 Buick Park Avenue?
89 Buick park ave install a heater coil
Where is radiator thermostat in a 1997 buick park avenue?
Type your answer here...where is my theremastat located
How do you program keyless entry remote for 1989 Buick Park Avenue?
The 1989 Buick Park Avenue does not come with a remote keyless entry. The keyless remote entry was not available till 1997.
Where is voltage regulator on 1989 Buick Park Avenue?
Inside the alternator.
How do the brake lines on 1989 Buick Park Avenue run?
by your mom
How do you reset change oil soon light on 1993 Buick park avenue?
= How do you reset change oil soon light on 1993 buick park avenue? =
Does the heat blower have a fuse on 1989 Buick park ave electra?
Yes
Where is a 1995 Buick Park Aves thermostat?
It will be (as in most cars) at the engine end of the top radiator hose.
Size of Brake lines for 1989 Buick Park Avenue?
I believe they are 3/16"
Where is the fuel pump located and how do you replace it on a 1989 Buick Park Avenue?
In the gas tank. Unless there is an access panel in the trunk, the tank must be removed to change the pump.
How you change a radiator in a 2001 parkavenue buick?
You can change a radiator in a 2001 Buick Park Avenue usi the instructions provided on the manual.
How do you change the thermostat in a 98 buick park ave?
Drain the radiator into a container and keep animals away as it is toxic. Remove the top radiator hose. Remove the water inlet from the engine, and pull the thermostat out. Replace the thermostat, mount the inlet back, and put the top hose back on. Fill the system with coolant.
