Drain about a gallon of coolant. Follow top radiator hose to engine. Leave hose connected to housing. Have a extended magnet handy. Remove the 2 bolts holding the housing. Use magnet so you don't drop bolts. With a little twisting & angle the hose/housing you & will be able to get it out. On replacing the hose/housing, I placed the bolts in the housing & used a thin wire around the bolts under the housing & then around to the top part of bolts.(holds the bolts in place) after getting the bolts started, I just took pliers & pulled the wires out & finished tightening. I use premtex # 2 on both sides of gasket DON"T use #1 you will never get it off again!
A 1997 Dodge Dakota does not have an EGR Valve.
No.No.
No cabin filter on a 1997 Dakota.
I am pretty sure its located under the goose neck that's at the end of the top raidator hose
A 1997 Dodge Dakota has two oxygen sensors.
Where is the thermostat on a 1997 chevy suburban and how do you change it?
if its the same size motor it will.
there in no egr valve on a 1997 dodge Dakota 5.2 318 Auto Zone is wrong
No they won't. They completely changed the Dakota bed in 1997
From 1997-2003 the Dodge durango is the same chassis as the dodge dakota, same powertrain.
There is not a mass air flow sensor on a 1997 Dodge Dakota.
most likly