Find the upper radiator hose then follow it to where it is clamped to the engine. That mounting is the thermostat cover; remove it and the thermostat is inside. When you replace it make very sure you put the new one in correctly. It should be marked or have a picture of how it faces in the instructions.
how do i replace a water hose in 1993 pontiac grand am
A 1993 Pontiac Grand Am weighs approximately 2,828 lbs. The Pontiac Grand Am stopped production in the year 2005. The car was replaced with the Pontiac G6.
if you have a 3.3l v6, then you follow the upper radiator hose to where it connects to the block. It's around the throttle. The place where the hose connects can be removed, and the thermostat is in there.
yes it will pontiacs are interchangable from the years 1993-1996
Make sure the radiator is full of coolant; if it is, then change your engine's thermostat which is located at the lower end of the top radiator hose within the water outlet.
Does a 1993 Grand Am have air bags
IF ITS A QUAD 4 THE HOUSING IS ON THE RIGHT SIDE OF THE VALVE COVER BY THE POWER STEERING BELT 2 BOLTS.
Follow the upper radiator hose from the radiator to the engine. Where it meets the engine there is the thermostat in the housing. Make sure you install the spring TOWARD the engine when replacing it. GoodluckJOe
If your 1993 Pontiac Grand Am will not shift into part, the transmission is probably seized up. The first step is ensuring the transmission fluid is not too low.
The remote trunk release for a 1993 Grand Prix is in the gove box.
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
underneith the front bumber twist counter clockwise replace bulb
how do you change an ignitoin swith on a 1993 grand am with a 3.3 liter
waste of time
Check the temperature sensor
Usually against the passenger firewall
i don't now
How do I get my door panel off
if its lifted but if not no
follow the top radiator hose to the engine. that is where your thermostat is. you will have to drain the radiator, remove the engine side of the hose and remove the thermostat housing to access it. remove thermostat clean mating surface of housing and engine, install thermostat, install housing, secure radiator hose, fill with coolant. start engine and check for leaks.
It must have a TIMING CHAIN because Gates ( they make timing belts etc. ) doesn't list a timing belt for the 3.3 liter V6 engine in a 1993 Pontiac Grand Am
Need to replace fuses on 1993 Grand Prix. Need to know ampere and color of the fuses.
The highest mileage was provided by the Pontiac Grand Am Regular and it gave 32 mpg on the highway and 21 in the city.
Yes It would if its 2.3L engine size. Also, fits Oldsmobile Achieva of same year. Thanks