Antique & Classic Cars

How do you change a water pump for a 1988 Mazda 121?


Top Answer
User Avatar
Wiki User
2011-09-13 00:11:00
2011-09-13 00:11:00

The water pump is located behind the Timing belt, the belt covers and belt needs to be removed to gain access to the water pump bolt,once you have removed the old one make sure you clean the surfaces where the new gasket is going, as it is a time consuming job to do it again


Related Questions

where is the water pump located in Mazda millenia

To change the water pump on a 1996 Mazda 626 you have to follow a few step. First you disconnect the miscombobulater from the alternator valve. Then you take the water pump off and put the new one on. Lastly you re -attach the miscombobulator and the altornator valve. There you have it.

i need to know what bolts to losen so i can change water pump belt on 1988 Nissan patherfinder

On a 1988 Mazda 626, the fuel pump relay is located in the fuel tank. Always disconnect the battery before beginning work on a fuel system.

Replacing the 1997 Mazda water pump will cost approximately $300. The water pump will cost about $75 and will require four hours of labor.

it is located in the fuel tank

can some one tell me if you can change the gasket on the back of the injection pump on 1983 mazda diesel pickup with out any problems

i have a 1995 madza b2300 truck & i believe that the 94 and 95's are identical. i am trying to remove and replace the water pump. i have all 4 bolts removed but i can't get the water pump off the bracket. thanks

The water pump from Mazda 626 is the same, all part from Mazda 626 work very good in the Kia Credos and Clarus.

The 1988 Mazda 323 1.6L non-turbo EFI engine requires an electric fuel pump, which is located inside the gas tank.

The 1999 monster 626 water pump is located on the front of the engine. You can follow the top radiator hose directly to the water pump.

the water pump is part of the timing belt or chain. you have to take the belt or chain off to change the water pump. if you change the water pump, change the belt too.

You can't. It is part of the fuel pump.

How do you replace the water pump on a 1988 Cadillac Seville?

The water pump is located behind the timing belt cover and is driven by the timing belt. You need to reove it to gain access to the water pump.

In order to remove the water pump on a 2000 Mazda Millennia, you must first remove the timing belt and the pulley for the water pump. Remove the pump itself by detaching the four bolts that are securing it. Next, replace any gaskets, install the new pump, then the pulley, and then the timing belt.

The water pump is under the timing belt cover. To access the water pump, you must first remove both belts, the water pump pully, and the timing belt cover.

part of the timing belt gears buy a manual for this repair chilton auto manuals are the best...

Drain the water from your 1988 Dodge Ram cooling system. Remove the water pump belt. Remove the water return hose. Remove the water pump retaining bolts. Reverse the process to install your new water pump.

How to change a water pump on a 94 hyundai scoupe?

how do you change a water pump on 1993 Mercury Cougar

how to change a water pump Kia Sedona 2002

how to change a water pump on a 2002 mercury mountineer

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.