Pontiac Grand Am

How do you change a wheel cylinder on 1997 Grand Am GT?

8910

Top Answer
User Avatar
Wiki User
Answered
2007-12-08 21:51:39
2007-12-08 21:51:39

Remove wheel Remove brake drum Loosen and remove brake line Remove mounting bolts Pry wheel cylinder off brake shoes Install new cylinder Replace brake lines Replace brake drum Bleed affected brake line

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


its easy if you go though the passagers side wheel well if this is on 3100 or 3400

How do you change the orifice tube on 1997 grand Cherokee jeep with 5.2 v/8

how do you reset change oil light on chrysler grand voyager minivan 1997

How do you change the supercharger belt tensioner in 1997 Pontiac Grand Prix GTP?

i just want to know how to remove the flywheel on a 1007 Grand AM Pontiac

Remove the wheel; remove the brake pads and caliper; the rotor should slide off of the lug bolts.

what do I need to change the 1997 Plymouth voyager transmission oil

by changing the steering wheel and fixing wats rong wif tha steering

Yes. Both use the same lug pattern. They will interchange.

you crack the lug nuts, jack the van, remove the lug nuts, take wheel off. put the wheel on, thread the lug nuts on, snug them with the tire iron, lower the car, and tighten them to ~140Nm.

How to change a heater core on a 1997 Pontiac grand am

The slave cylinder is on the input shaft of the transmission at the throw out bearing. The transmission will have to be removed to change it.

Six cylinder, on the lower passenger side of the engine. Eight cylinder, lower drivers side of the engine.

Remove the tire and wheel from your 1997 Chevy Lumina. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new wheel bearing.

153624 # IS ON THE INTAKE MANIFOLD NEXT TO THE THROTEL BODY.

It is just below the Master Cylinder and the Power Booster assembly.

can i change 1 fuel injector on 4.3 6 cylinder silverado 2003.

No. It's rear wheel drive vs. front wheel drive. Engines will not match.

seeing you have the old one off, just place new wheel cylinder on backing plate and put the 2 bolts in the new cylinder and tighten then down and then reinstall the brake line into the new cylinder and it's on, just don't forget to bleed your rear brakes when you have it all back together.

How to change upper and lower ball joints on a 1997 ford explorer all wheel drive?

Use wheel adapters. You can get them at performance shop or wheel/rim shop.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.