Want this question answered?
how to remove cover to replace ignition lock cylinder and what type of tools do i need
can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode
pull it really hard
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
Yes, the 2001 ignition switch for a 2000 Chevrolet Tracker will fit just fine. Other years the switch fits are 1999 to 2004.
The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.
Possibly a neutral lockout switch, possibly a bad connection, possibly an ignition switch.
immobilizer is in the key and pickup ring on the ignition lock
Change the ignition switch. About 40$ and 30 mins of your time. Had it happen on several Trailblazers and envoys.
I had a similar problem w/ a 2000 Regal. The ignition switch has a circuit that is shared with the turn signals (draw up to 9A) and also controls the ignition relay. That circuit had a bad contact in the switch. I work in electronics & I worked @ this for quite a while. Had the ignition switch changed out (about $60 for switch + labor) . You still use the same lock so no change of key is required. Changed out over 3 yrs. ago & no issues since.
i broke the key off in the ignition. got it out and got a new key. now when i try to hook up battery it trys to start even with the run switch off.
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.