You have to pull the entire axle. Take off the tire and wheel hub. unbolt the tie rod from the wheel hub. unbolt strut assembly from wheel hub. Pull transaxle drain plug to empty as much fluid as possible. Use a pry bar to remove the right side drive shaft from the transaxle. Note that some fluid will still leak, despite having drained the transaxle. use a screwdriver to remove the old seal. Moisten new seal with fresh transaxle fluid prior to installing. Install new seal with a seal installer tool and mallet, by gently tapping it into place. Reinstall axle by following steps in reverse order. Don't forget to replenish transaxle fluid with SPIII fluid!
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
170 pounds
how to install cv axle on a 2002 e32o meredes
First, remove the axle. Then, user a large screwdriver or a seal remover to remove the seal. Tap a new seal into place with a hammer. Reinstall the axle and fill the differential lubricant.
Trans looks like it is bad in 2001 Hyundai plantar,liquid in garage floor.Can it be from lack of gear oil I changed axle and lost some fluid
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Front axle nut is 35mm
what is the Torque spec for rear axle hub nut on a 2002 ford explorer
36mm
One of them is 112 inches from axle to axle. The other one is 120 inches from axle to axle.
From my understanding there is no way to change the center support bearing I was told you have to change the axle to change it and then they said, theres no way to change it so I have to break down and buy a whole new driveshaft
35mm