answersLogoWhite

0

call my dad he's a g.m. mechanic,Ronnie Allen (304)655-8111

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What caused ball joint to break in half lower ball joint snaped in half?

The rubber boots aroundÊthe lower ball joints can become old and worn, cracking and allowing dirt, water, and other debris onto the lower ball joints. This causes them to wear out quickly.ÊSometimes they just wear out.


How long does it take to install upper and lower ball joints on a 1988 Jaguar XJ6?

Half an hour


The how to change CV half-shaft on a 1997 dodge stratus ES?

how to chance a CV shaft on a 1997 dodge stratus


How do you change the you u joints on a 1992 4 runner?

you take the leaf spring and cut it on half and then weld it back on and our problem is fixed


How do you change u-joints in a 1999 Toyota 4runner?

Remove the caps, bang out the u-joint with a hammer. It would help to know which u-joints you had in mind, because you might also need to know the process of removing the driveshaft (if those are the u-joints) or the axle half shafts (if those are the u-joints).


What is the procedure to remove the front half shafts on a 1997 dodge fwd to replace the small u-joints?

To remove the front half shafts on a 1997 Dodge FWD, first, ensure the vehicle is safely lifted and supported. Begin by removing the wheel and tire, then detach the brake caliper and rotor for better access. Next, remove the axle nut and any mounting bolts securing the half shaft to the transmission and wheel hub. Finally, carefully pull out the half shaft from the hub and transmission, allowing for the replacement of the small U-joints.


What is a half ball called?

a hemisphere.


What are the weaknesses of a half lap joints wood?

Some weaknesses of half lap joints in wood include reduced strength compared to other types of joints, such as dovetail or mortise and tenon joints. They can also be more difficult to align properly during assembly, leading to potential gaps or misalignment. Additionally, half lap joints may not be as aesthetically pleasing, as the end grain is visible on both pieces of wood.


What are the two types of joints in construction?

Expansion joints. Butt,lap,half-housed,mortise/tenon and mitre joints to name some common ones.


Game played with a half-inch ball?

The game played with a half inch ball is ROULETTE


What is a half back used for in football?

The half back is actually misleading. As aligned from the ball at the line of scrimmage, the half back, sometimes called a tailback is furthest from the ball and is the primary ball carrier.


What does a half of an 8 ball weigh?

Half of an 8-ball (4.5 grams) would weigh approximately 2.25 grams.