0
What is the procedure to remove the front half shafts on a 1997 dodge fwd to replace the small u-joints?
To remove the front half shafts on a 1997 Dodge FWD, first, ensure the vehicle is safely lifted and supported. Begin by removing the wheel and tire, then detach the brake caliper and rotor for better access. Next, remove the axle nut and any mounting bolts securing the half shaft to the transmission and wheel hub. Finally, carefully pull out the half shaft from the hub and transmission, allowing for the replacement of the small U-joints.
What else can I help you with?
Does a 1991 Toyota truck 4wd 4 cylinders 24L have cvjoints or ujoints?
It has both. As a rule:--U-Joints are usually found on drive shafts and CV joints are usually found on half shafts.
Is a 94 crown vic and 95 town car drive shaft the same length?
Most probably,but to be sure measure both shafts from the centres of the ujoints and make sure the measurements are the same. Hope this helps.
Do you have to disconnect the drive shafts to replace the clutch and pressure plate 0f a 1989 Mazda 626 5 speed?
yes, u need to disconnect drive shafts to enable you to remove trans mission to get at cluth and pressure plate
What changes do you need to make an 2008 Dodge Magnum towable 4 wheels on the ground?
It is not unless you remove the drive shafts.It is not unless you remove the drive shafts.
How do you replace Callaway shafts?
Callaway clubs differ from other clubs because they have bore through shafts. These can be difficult to put in, so you should really get your local pro or clubfitter to replace them.
How do you remove the drive shafts from a 406 estate?
i dont understand the Q
How do you replace the front half shafts on a 2003 GMC Envoy?
Big job. Hope you have a repair manual or have done the job before. I don't have enough time to detail the procedure but if anyone else feels so motivated please do!
How do you replace the clutch in a Nissan primera?
without sounding sarcastic you'd remove the old and replace with a new unit. i.e remove wheels, drop off bottom arms, remove drive shafts, gearbox (drain oil first) and then hey presto its there. step by step would be a haynes manual but if your competent and have a few tools do it on your drive with a few cups of tea.
How do you Remove and refit drive shafts on a ford focus ST?
smoke a pint, then eat a bone
How do you replace 2002 kia sportage spark plugs?
if you have 2.4l dohv engine, remove the intake tube ,then there is a rectangle black cover with 4 bolts,take that off and you will see spark plugs under it with deep shafts to the plugs.
How do I change the Check engine light bulb in a 1996 crown Victoria?
To change the check engine light bulb on a 1996 Crown Victoria you need to remove the molding from around the instrument panel. Next, remove the headlight knob and shafts. Locate the light bulb and turn counterclockwise to remove. Reverse directions to replace with a new bulb.
What do you need to remove to replace clutch on 1996 Mercury Tracer 1.9?
To replace the clutch on a 1996 Mercury Tracer 1.9, you need to remove several components, including the transmission, which requires disconnecting the battery, removing the drive shafts, and detaching the transmission mount and linkage. You’ll also need to take off the starter motor, exhaust components, and possibly the crossmember for additional clearance. Once the transmission is out, you can access and replace the clutch assembly.
