Want this question answered?
This was for a 1994 but try searching here. How do you Change a fan belt on 94 prizm?
On my 94 Diamante, I just take off the negative terminal at the battery and then put it back on. It helps if you have the terminal not too tight. snug enough that it stays clamped on and loose enough to be able to pull it off.
speed sensor location Mitsubishi montero 94 ls, 3.0
yes.
155 mph.
i dnt know
Yes i suppose so, as i have a buddy who did the same.
94 Quest doesn't have a serpentine belt, just three belts for alt, AC and water pump.
Inspect at 30,000 and change at 60,000 miles ( according to the Gates website - they make timing belts etc . )
A common problem with all early model Diamante's (92-96)is the IAC or idle air contoller or idle stepper motor stops operating properly.If your D is idling rough or stops,look at the rpm gauge.If it falls below the normal range check the IAC.Replace with known good IAC and see if the problem persists.It's a quick and easy operation to change the IAC and will rule out this possiblity before causing you a headache and $$ down the drain.A bad IAC may lead to ECU problems over time.
I would Invest in a Haynes Manual.
When we changed the belts on our '94 Grand Voyager the belts made the most awful sqealing noise. We "lubricated the belts with a drop of dawn dish soap and the sqealing went away. You can also try belt dressing. If that doesn't work... the people at Auto Zone are very helpful in explaining how to change the bearings youself.