This is a copy of the post for tail lights, but it's the same process. The tail light is held on by two screws and two pins. You will see the two screws when you open the back hatch. The two pins are on the opposite side of the tail light in the same general position as the screws. After you remove the two screws, you will find that the tail light assembly can be rocked a little but is still firmly attached. Proceed carefully as you can break the pins since they are only made of plastic. Gently pull the side of the tail light with the screws toward you about 1/8 of an inch. At the top center of the tail light you should now be able to slip you finger tips in to the opening. The plastic is a little sharp so use caution. Gently pull the tail light straight back towards you. You will feel the pin release. At that point you will understand how the whole thing goes together. To release the bottom pin you will need to slip a flat head screwdriver between the tail light and the metal vehicle body. With gentle prying pressure you will feel the bottom pin release. The assembly containing the bulb releases after about one-third of a turn. The bulb pulls easily from the socket with light pressure. The tail light assembly goes back together easily and is done in reverse. You will hear the pins click when they have reattached. It only requires light pressure. Then just reinstall the two screws. Don't over tighten the screws as you can crack the plastic.
WHICH brake light?
how to change the rear tail light bulb on a 2004 Nissan maxima
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
Change the brake pads sensors. You must change them after every brake pad swap.
The brake fluid reservoir
I need step by step to replace brake cables on 2004 Ford Escape
A problem has been detected with the Anti-lock Brake System It could be a fuse , a sensor , or some other problem As long as the red " BRAKE " light is not on in your dash you still have " normal " brakes
push on the rear brake light then lift up and pull away. disconect the harness and ur done. install new one in reverse order
How do you change rear brake drum on a 2004 Chevy Venture?
I have 05 with no brake lights
2004 Honda Accord Brake Light Bulb Numbers - See sources and related links below.
how do you reset brake warning light 0n 745li bmw