answersLogoWhite

0


Best Answer

You have to take the whole light assembly off by going through the trunk. There is a panel the snaps off the wall of your trunk. In there are a few nuts I believe are 10M that you will take off and the assembly will pull away from your car.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change brake lights on 2000 Mitsubishi Eclipse?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1997 Mitsubishi eclipse brake lights stuck on?

check your clutch and brake fluid


How do you change the brake lights on a 2002 Mitsubishi Eclipse?

You must open the hatch, remove the plastic strips then you must unbolt the tail lamp assembly and remove the bulb.


1997 Mitsubishi eclipse taillights stay on?

Perhaps brake lights? Check the stoplight switch at the upper end of the brake pedal under dash area


Minimum brake rotor thickness for a 2003 Mitsubishi Eclipse GTS?

The brake rotor thickness for your 2003 Mitsubishi Eclipse, is 0.75. The rotor should not be used if the thickness is less than this.


How do you change the front brake rotor 1991 eclipse?

Jack up the front of your 1991 Mitsubishi Eclipse. Remove the brake pad assembly. Loosen the brake rotor by tapping on it with a hammer or mallet. Slide the brake rotor off. Reverse the process to install the new brake rotor.


How do you change a brake light bulb in a 2001 Mitsubishi eclipse gt?

there are plastic covers over them on the inside of the trunk that you pop off


What brake fluid do is use on a 2003 Mitsubishi Eclipse?

DOT 3


How do you replace the light bulbs on the brake lights of a 2000 Mitsubishi Eclipse?

Inside the trunk behind where the brake lights are are a plastic cover. Remove that and you will see one bolt. Reach in to the far side of the light and you will find the second bolt. Remove those and the brake lights can be pulled out. Now just twist the bulb holders and there are your brake light bulbs.


What is the Minimum brake rotor thickness on 2002 Mitsubishi eclipse?

The minimum brake rotor thickness for a 2002 Mitsubishi Eclipse is 1.17 inches. When it falls below this thickness, braking performance will suffer and must be replaced.


Where can you find a diagram for the parking brake on a 1998 Mitsubishi eclipse?

try google


How do you remove a brake line from the caliper on a Mitsubishi Eclipse?

you smash the car, and eat it


If your battery and brake warning lights come on together in your 2005 Mitsubishi Eclipse what is wrong?

you don't really know unless you get the vehicle tested...most likely it would be your battery or your brakes