answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change clutch slave cylinder on a 99 Isuzu amigo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the clutch on a 92 amigo Isuzu?

i have u aswer but i dont exactly.....


Where is the clutch slave cylinder on a 98 Isuzu Amigo located?

The clutch slave cylinder is attached to the middle of the transmission towards the passenger side. It is easy to see by looking under the car at the passenger side door.


On a 1990 Isuzu Amigo what would cause the clutch pedal to stick to the floor?

if its hydraulic there could be air in your line. bleed your clutch and refill.


How do you tell if a 1999 Isuzu amigo is a 4 or 6 cylinder?

Count the sparkplug wires.


How much will it cost to change my Isuzu amigo to automatic?

About 5.00$


How do you hook up the clutch cable on an Isuzu amigo?

hey it is called calling the cable box company and asking them that is how I did it


How do you replace slave cylinder on a 1990 Isuzu amigo?

unbolt from trans.bolt on new one bleed system


What is the average MPG of an Isuzu Amigo?

The average MPG of an Isuzu Amigo is between 17.2 to 18.7. Isuzu Amigo has the convertible styling of a two door wagon. Some of Isuzu Amigo models come with standard cruise control.


Is the Isuzu Amigo still for sale?

Yes. You can find the Isuzu Amigo at the Honda sale dealers.


What is the firing order for a 1994 Isuzu amigo 2 wheel drive. and which cylinder is the 1?

1 3 4 2 Number 1 Cylinder is the forward most cylinder.


How much fuel pressure for Isuzu amigo?

how much fuel pressure should a 1999 Isuzu amigo have


How do you change Isuzu amigo radio?

To change the radio in an Isuzu Amigo, first remove the bezel from around the radio. Then, release the side clips from the radio itself and pull it out of the dashboard. Remove the wiring from the back of the radio and add this to the new radio. Reverse the process to install the new radio.