1. Remove the V-Bank cover.
2. Drain the engine coolant.
3. Remove the radiator cap from the radiator reservoir.
Caution: To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot, as fluid and steam can be blown out under pressure
4. Remove the water filler plug from the throttle body.
5. Remove the 3 drain plugs on the engine and radiator, and drain the coolant.
6. Close the 3 drain plugs. Tighten the drain plug to 108 inch lbs. (12.7 Nm).
7. Refill with engine coolant.
8. Slowly fill coolant to the throttle body until it is full.
Note: Use of improper coolants may damage engine cooling system.
Note: Use "Toyota Long Life Coolant" or equivalent and mix it with plain water according to the manufacturer's directions.
9. Use of the coolant which includes more than 50% (freezing protection down to −31°F (−35°C)) or 60% (freezing protection down to −58°F (−50°C)) of ethylene−glycol is recommended, but not more than 70%.
Note: Do not use an alcohol type coolant or plain water alone.
The coolant should be mixed with plain water (preferably demineralized water or distilled water). Capacity (w/ Heater): 11.6 qts
10. Install the water filler plug to the throttle body. Tighten plug to 33 ft. lbs. (45 Nm).
11. Slowly pour coolant into the radiator reservoir until it is "FULL".
12. Install the radiator cap.
13. Bleed the cooling system.
14. Start the engine, and open the heater water valve.
15. Maintain the engine speed at 2,000 − 2,500 rpm, and warm up the engine.
16. Stop the engine, and wait until the engine coolant cools down.
17. Refill coolant into the reservoir until it is "FULL".
18. Check engine coolant for leaks.
19. Check engine coolant specific gravity correctly.
20. Reinstall the V-Bank cover.
take it to a muffler shop
Yes, most cars today, especially those with high performance engines are.
in the trunk behind the rear seat,on driver side good luck
don't get a Lexus
how do you change spark plugs on 1995 Lexus es300
1990-1994 = 250hp 1995-1997 = 260hp 1998-2000 = 290hp 2001-2006 = 290hp 2007-present = 380hp
I have a 1990 LS400 but have never removed the door panel. Go to one of my favorite sites lexusownersclub.com as they have forums with all kinds of information. Here is the exact link http://us.lexusownersclub.com/forums/index.php?showtopic=23097 vbdenny
Any 50/50 mixture of regular green antifreeze.
I have the same problem and after researching found it not to be as simple as a lose connection, etc. Here's a linkto another site that you'll find your answer for this problem. http://www.clublexus.com/forums/ls400-forum/40025-instrument-cluster-circuit-board-is-bad-1000-bucks.html
You have to remove the wheel well lining to have access.
Around 90,000 to be safe but I've seen them changed at 100,000 miles
How do you install a oil pan gasket on 1995 Lexus sc400