Instrument Cluster Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the cluster opening trim panel. 3. On vehicles equipped with an automatic transmission, remove the loop on the indicator cable assembly from the retainer pin. Remove the thumbwheel bracket screw from the cable bracket and slide the bracket out of the slot in the steering column tube. 4. Remove the instrumental cluster retaining bolts. 5. Pull the instrumental cluster out of the instrument panel. 6. Detach the electrical connectors. 7. Remove the instrument cluster. To install; 8. The installation is the reverse of the removal. 9. Connect the battery cable, and check the operation of all gauges, lights and signals. *** Turn the light bulb housing counter clock wise. Sometimes they are very hard to turn. Don't be afraid to turn them. ***
could be the alternator is about to go out
How to change dash lights on a 95 Ford Ranger?
Vehicle is in need of service...
Check owner's manual. If you don't have one copy and paste link below; www.fleet.ford.com/maintenance/owners_manuals
To change the gauge lights on a 1998 Ford Taurus SE, the dash cover has to be removed to access the burned out bulbs. There are screws and clips holding the dash cover on.
Check parking/tailight fuse
yes
You have to take the whole front console off including all the plastic moldings, and finally get to the dash board. You can find the lights bulbs behind it. It took me 3+ hours to get this done. good luck.
Should be parking/tailight fuse
there is a light we dont know what it means
Check the fuse or switch.
the HEATER CORE can be removed by removing the dash. how do i ghange the dash