Remove the doghouse, mark spark plug wires if they aren't already, remove spark plug wires, remove 2 screws holding the distributor cap in place. Installation is reverse of removal.
It is on the back of the intake manifold just in front of the distributor. If it is a HEI vehicle it will be in the center of the distributor cap. (distributor cap will look larger than normal)
In the distributor,you need to remove the dist cap & then remove the rotor and it will be mounted to the distributor housing
There in no right answer. It really can be any post just depends on how the distributor was dropped in. I set mine up to 1 is right after the 3 wires that plug into the cap
There is no distributor cap, only a ciol pack that the plug wires go to
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
Yes, a 1997 Chevy Cavalier does have a distributor cap. The distributor does not have points and a condenser. This part is one electronic unit.
If your S10 has a 2.2L engine, it doesn't have a distributor cap.
It doesn't have a distributor cap.
I don't know what your specific problem is, but there is no distributor cap.
It is in the very back top side of the engine. Just follow the spark plug wires going to the rear of the engine and you will see all of them stuck into the distributer cap.
on this old distributor there is a cap that holds the wires in place on the distributor. Is there a trick to remove top cap?
The 93 Beretta does not have a distributor, it has coil packs.