Well if you are asking how to remove them from the car? To remove the four bolts from under the lower air dam. As you look up from underneath you will see two 12 mm bolts that need to be removed and the light will slid forward out the pocket they are located in. There will be a single water proof connector which you will have to separate to remove it from the car. The bulb can be accessed by twisting the rubber grommet which will revile the back of the bulb and the metal retaining clip to remove it.
Pull the turn signal stick towards you.
Remove the fog light retaining bolt. Remove the fog light wiring harness. The fog light will come out. Reverse the process to install the new fog light.
By buying fog lights and installing them.
How do i change the fog lights on a 2005 Kia Sedona? Answer Behind Your Fog Lights Remove The Nut's And Bolt's Can't Go Wrong With Wireing The Wires Are Different Colors
The fog lights are turned on by pressing the fog light button on the headlight switch. On my truck, you have to pull the switch out that turns the regular lights on.
Pull out on the headlight switch, and then press the fog light switch button in.
Hello, all you have to do is turn the back of the light post and pill the lights out for both the fog lamps and the break lights. For the break lights, its less work to change.
The light switch pulls out to turn on the fog lights. They won't come on with the brights. ----turn on the headlights and gently pull out that same knob--note fog lights will not work if hi-beam are on....junboy33
== ==
If it is equipped with fog lights, you turn them on by pulling the headlight switch out one notch after turning the headlights on.
can you change fog lights on 2007 hyundia sante fe dealership said it was not optional?
pull headlight switch OUT toward you and make sure the fog light switch is pressed. It is located on the dash near the radio if they are factory lights.