first remove both the caliper bolts holding the caliper to the cage bracket. Once removed, pull of the brake caliper and remove the brake pads. Lubricate "with special grease" all contact points the pad with contact. INSTALL new pads. Next you will need to depress the brake piston to set the caliper back into place. There are special tools used to do this but mainly mechanics only have them. in this case a basic c-clamp tool from your local hardwear store will do. use the old brake pad as a flat service to push the caliper back into its rest position SLOWLY!!! if you do it fast you can pop out the piston. Once it is retracted put the caliper back on along w/ the two bolts, tighten them up, SET THE PEDAL BEFORE DRIVING! do this by gently pushing the brake pedal to the floor about 10 times (NOT ALL THE WAY, ONLY ABOUT HALF WAY) then your done
what tools are needed
The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.
How do you take out a radio in a 1996 Acura TL
change a front directional on a xj6 1996
Be sure to change both front brake hoses. I didn't and my calipers would lock up.
Take it out and put the new one in.
90,000 miles
How to Install Front Brake Pads check related link below
10 or 11mm socket rench and a C-clamp
how to change brake lines on a 1996 ford econoline e-150
no