0
you need to take the front tire off, then you need to remove the brake calbiter there should be two bolts holding it on after you move the calbiter bolts you then can take the brake pad off,then take a c clamp and turn the pistion in, but make sure you do one side at a time,you when you push the pistion it you then put the new brake pad on the same way they came off ,then put calbiter back on and tighting up the calbiter bolts.you can put the tire back on. hope this help you out
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace rear brakes on a 1993 Toyota 4runner I am unable to get the drums off?
Hit it with a hammer to break it loose
Does Ford 1993 E350 have front disc brakes?
Yes.
How do you change brake pads on a 1993 Lincoln mark viii?
Front brakes are done the usual way but the back pistons have to be screwed into the calibers not pushed in.
How do you replace 1993 Toyota pickup kickdown cable?
how to change a toyota 4runner kickdown kabel
How do i change the brakes on a 89' Ford Festiva?
In fact it' a 1993 festiva standard. How put off old plates on front discs braques?tancks!Constant
Where is the spare tire change kit located on 1993 Toyota 4Runner?
Under the passengers seat that is behind the driver.
Where is the obd2 port on 1993 4Runner?
1993 is OBD 1
What type of freon is used in 93 4Runner?
A 1993 Toyota 4Runner uses R12 refrigerant. The 1993 Toyota 4Runner requires 30 ounces of R12 for all engine types.
On a 1993 Ranger rear brakes does the short shoe or the long shoe go toward the front?
The short shoe goes on the front
How do you change 1993 Honda Accord LX back disc brakes?
Pads: Similar to front disk pads, except that the caliper piston is retracted by turning clockwise, not pushed directly in.
What would make the brakes on the front of a 1993 Toyota celica not release?
lost the spring for brake pad
1993 toyata 4 runner front door panel removal?
To remove the front door panel on a 1993 4Runner unscrew and pull off the mounting hardware, including the clips. The door panel will need just need to be pulled off.
