0
- Between the headlights there are two screws and a plastic clip that needs to be removed.
- On both ends of the bumper cover there are two 10MM bolts that need to be removed. On is inside the wheel well under the wheel well liner, and the other is on the bottom side of the bumper cover near the wheel well.
- In the front of the car there are 2-3 more plastic clips that hold the front bumper on that need to be removed.
I have also included an instructional video below that will show you the procedure for doing this.
Hope this helps,
1ATony
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you fix oil in spark plugs on Toyota corolla?
Change the valve cover gasket.
Where is timing marks on 1994 Toyota Corolla?
The timing marks on a 1994 Toyota Corolla are located on the crankshaft cover. The crankshaft cover is usually located at the very bottom of an engine.
How do you change the clock and cigerette lighter fuse in Toyota corolla 1992 US models?
Look on the cover of the fusbox there's a map.. of the fusebox idiot!
Where is the PVC valve on a 1998 Toyota Corolla?
The PCV valve on a 1998 Toyota Corolla is located on top of the engine, on the passenger side. It connects the intake manifold with the valve cover.
Can you get a fuse box diagram for a 1990 Toyota Corolla?
A fuse box diagram is found under the fuse box. There is a sticker imprinted underneath the cover of the box a 1990 Toyota Corolla.
How do you change a rear license plate light on a 1991 Toyota Corolla?
Changing a rear license plate light on a 1991 Toyota Corolla will be very easy to do. You need to take the license plate off and then unscrew all the plastic screws holding the light cover in place. After the screws are out, remove the cover and unscrew the old bulb and replace it with a new one.
Fuse box diagram for 2003 Toyota Corolla CE?
The fuse box diagram for a 2003 Toyota Corolla CE is located on the rear of the box cover. It can also be found within the service manual.
How much does it cost to replace rear bumper on 2013 Toyota Corolla S?
A bumper COVER, (The real part that absorbs impact up to 5mph, with no damage is behind the cover. For the purpose of this explanation I will discuss the cover only, what you can see) used is about $100, and no control of color. New, $215 for aftermarket, and $295 from Dealer. Advantage of dealer is you can match color, they are NOT painted. Labor is about 4 hours @$75= $300+Bumper total $600. I have given you a figure for quality parts and work, there are less expensive (read: not as good) ways
How do you you replace a headlight on a 2003 Toyota Corolla?
AnswerHow to replace the headlight (low beam) on a Toyota Corolla 2003? To replace the entire headlamp assy you must remove the bumper cover. There are fasteners across the top, inside fender skirt and along the bottom and also a few clips inside the grill that are accessible from underneath. Three bolts fasten headlamp assy to the radiator support and there are three quick electrical connections.
Where are the spark plugs on a Toyota Corolla 2001?
under the plastic head cover (top of the motor) four bolts
Where is the airbag control module located on a 2003 Toyota corolla?
center of the steering wheel, under the horn cover
How do you change a front bumper cover on 2001 Escape?
take it off and put the new bumper on replacing all screws nuts and bolts from the first bumper
