0
Where is the airbag control module located on a 2003 Toyota corolla?
Wiki User
∙ 10y ago
center of the steering wheel, under the horn cover
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is the airbag module located in a 2006 Toyota corolla?
look for places that say airbag
How do you reset air bag light on a 2003 Toyota Corolla?
my2003 toyota corolla the airbag light is on
Where is the airbag brain located on a Toyota Corolla?
Somewhere above the driver's seat, and below the ceiling, depending on the height of the driver.
Where is the airbag control module located in a 1997 Toyota 4Runner?
Below the center console.
Where is the airbag located in a 1989 Toyota Camry?
Don't think the 1989 Toyota Camry came with an airbag system.
How can you reset the airbag light on a 1993 Toyota Corolla?
You will first need to check that the airbag has been properly set up. Then you can go into your settings and get it all reset.
Where is the airbag control module for a 2002 Acura TL located?
The 2002 Acura airbag control module is located on the firewall in the engine compartment. The airbag control module will be on the drivers side of the firewall.
What does it mean when your airbag light comes on on your Toyota Corolla?
It means it needs to be serviced at the dealer. The integrity of this device is now questionable and probably will not protect you adequately in a crash where the airbag gets deployed.
How do you disengage a seat belt sensor for a 2005 Toyota corolla?
Not sure if the 2005 is the same as the 2006 model but the only way I know is to disengage both airbag plugs under each seat. No beep but also no airbag.
Where is the airbag module located on a 04 sienna?
The airbag module on an 04 Toyota Sienna is located at the front of the engine compartment. It monitors for impacts which cross a threshold which triggers the airbags.
Where dodge challenger airbag control module located?
under the radio
How do you disconnect wires from old driver airbag of 06 Toyota Corolla to install new one?
Disconnect the battery and the wire has a conector on it . undo clip and slide apart .
