Jack up the car. Take off your tire. Find the bolt on the back of the caliper and take it off. This should release the caliper, pull the caliper off the disc. Now you should be able to take the pad out. Replace the pad. You'll need a special tool to reset the caliper. As the brakes wear down, the caliper gets tighter so the brakes still work. I'm not sure exactly what its called, but you can borrow one from auto zone. Follow the instructions that come with it to reset the caliper. Slide the caliper back over the disc. If it doesn't go on, you need to reset the caliper more. Put the relese bolt back in. Put your tire back on. Drive slowly and test the brakes. Hope that helps at least a little bit.
change the body style of it which is like a thousand something dollars
The back and front are different and the calipers are removed different ways. Other than that they should be like any other brake.
you have to either take the front bumper off or remove the front wheel and wheel well. and the rest should be pretty self explanatory.
how do i remove the starter motor Mazda rx8
You can't. It is part of the fuel pump.
The 2011 version of the Mazda RX8 was the last model produced by Mazda. Models of the Mazda RX8 are still available for purchase and can be found online.
WE CAN GET MAZDA RX8 IN GTA SAN ANDREAS By installing rx8 mod
It's under the hood, near the front, covered by a plastic cover.
wher can you find the chassis number of mazda rx8
Rx8, but not by too much.
Underneath the PCM on the passenger side front of engine compartment
how good were they Nazda RX8 2004