Want this question answered?
pivture to change right turn signal
reach up under front bumper and twist the bulb out.
assuming you mean the light bulbs, see the answer to "how do you change turn signal lamps both front and rear on a 96 mercury grand marquis" right here in WikiAnswers.
trouble putting right front signal bulb in.
you have to go inside engine compartment to the front right side,then reach in and disconnect signal/parking bulb holder electrical connector.Then rotate the turn signal bulb holder 1/4 turn COUNTERCLOCKWISE to remove it.
the socket should just turn out in the back under the hood.
on what car
remove passenger side signal front light first then passenger headlight and horn should be right behind below the side passenger signal light!
It has been my experience that a rapid turn signal indicates there is a burnt-out signal light bulb (either front or rear) on the side of the rapid blinking signal. If the right signal is blinking rapidly, the problem is in the signal lights for the right side (front or rear) of the vehicle. Turn the rapid signal on and step out of the vehicle to find which bulb is not lighting.
More than likely you have a burnt out bulb at the front signal light, rear signal light, or brake light on the right side.
It's right up in front on the dash. It's part of the hazard switch.
Try checking the right turn signal light bulbs, front and back. Sometimes one of the filaments inside the bulb can break and short out causing the signal not to blink. If you do go this route you might as well change them while you're there.