Did this today, just don't break the lines!
- De-pressurize the fuel system
- remove the fuel pump relay (From the fuse panel in the engine bay) and crank the motor for 10-20sec
- clean away any dirt around the connection
- push firmly towards the filter
- squeeze firmly (pliers NOT required) and pull off
some fuel will spill out. (There is atool that is sold from various outlets, Autobarn etc)
Make sure the connections go back on properly.
Good Luck!
Location of fuel filter on VT CommodoreThe fuel filter is located behind the fuel tank, right near the differential. It is attached to the chassis via a plastic clip, and is a metal in line type. Cost about $20 to replace. Just ensure you purchase the correct one, as the fuel line has special fittings to stop any leakage.
Holden VT Commodore was created in 1997.
do you need to take the engine out to change the sump on a vt can it be done without taken the engine out
The Fuel Pump in a VT is located in the Fuel tank, as in most cars. I think you need to remove the fuel tank to replace, obviously great care needs to be taken.
IT COULD BE THE CRANK ANGLE SENSOR OR THE IN TANK FUEL PUMP
turn signal located on VT commodore
how much to get brake pads and rotors replaced on a holden vt commodore
Yeh it will i have changed 3 different pod filters since iv had the car i currently have a K&N Filter on it :)
That sounds about right on this vehicle. It is a very difficult job.
1.5mm
Passenger side kick panel
Replacing a head gasket on a VT Commodore instructions can be found in a manual. Manuals can be bought at most auto parts retailers or in book stores.