It depends on which line is bad. There is more than one line. Once you have figured out which is bad, get a repair kit, from the local parts store. Dorman makes a lot of repair kits. You may also need to run some steel line so you will need a flaring tool and may require dropping the gas tank. These are high pressure lines, not like the old cars so they must be repaired properly. We do a lot of that type of work here. It is messy and time consuming. The lines snake around in a lot of inaccessible places and are not a lot of fun to do. It is very helpful to do it on a lift. I couldn't imagine trying this on the ground. While doing it, try not to disturb any other lines (Like the brake lines) if you have a rotted out fuel line the brake lines may not be far behind.
Good Luck,
Paul
Midas of Dartmouth, MA
replace the fuel sending unit in the gas tank.
drop the fuel tank. the pump is in the tank.
It depends if it has the lt-1 or the ls-1 vette engine i have a 95 camaro with a lt-1 and i put 93 octane fuel in it 100% of the time
does a 99 camaro fornt end fit a 95 camaro
Yes. NEW ANSWER: Yes it will fit but the wireing harness,fuel pump and the computer system on the 97 will not hook up to the 95 engine So therefore it will not work.
it is located on the drivers side floor under the left panel.
how to bypass vats on 95 camaro
It is under the car towards the rear end. Drivers side.
Most of them are accessable from within the trunk behind the carpet/mat.
The fuel line is located on the drivers side on the top of the frame.
GM vehicles do not use inertia/reset switches
Yes