0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What type of transmission fluid do you use for a 1987 Plymouth reliant?
Mopar ATF+3 or Mopar ATF+4
1989 Plymouth Reliant tail lights and license plate light wont work checked wiring bulbs and fuses?
had 1987 dodge Aries with same thing wrong, its was bad ground wire just ran new ground wire from rear harness to a screw I put in rear metal tail panel it worked.
Timing diagram for 1987 2.2 Plymouth reliant?
To set the timing you unplug the temp. sensor in the thermostat housing and set the timing to 12 degrees before T.C. with the automatic trans.
How much does a 1987 Plymouth Voyager weigh?
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.
When was Plymouth Sundance created?
Plymouth Sundance was created in 1987.
How much does a Plymouth Voyager weigh?
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.
Did 1987 Plymouth have air bags?
no
Where can you find a diagram for the fuse box and fuse listings for a 1987 Plymouth Neon?
The fuses are listed on the cover of the fuse box. If you need a schematic or wiring diagram you will probably have to buy a service/repair manual.
Where are the fuses in a Chrysler LeBaron?
I have a 1987 Lebaron and the fuses are inside the glove box on the right side.
Where is the fuel filter for a 1987 Plymouth horizon?
where is the fuel filter on a 1987 plymouyh horizon?
What freon do you use on a 1987 Plymouth wagon?
R-12 was used in 1987 vehicles.
How do you adjust the timing belt on a 1987 Plymouth Reliant 2.2 liter?
on 87 Plymouth reliant just above the crankshaft pully sligtly to the left theirs a head of a bolt that can be seen and u can loosen it but to adjust it the bottom plastic cover needs to come off and a little tool is put into a slot to put tension on the belt then retighten the bolt it works on a cam system its a round idler pully but the bolt is off center i been putting mine off because u have to get that bottom cover off that means all the belts basicly the whole front
