All you have to do is open the hood. On the back of the head light, pull the plug off. Depending on the last time the lights were changed it may be difficult. I know when I changed mine I broke one of them. Once you get the plug off, pull of the rubber gasket off. Then there will be a gold screw holding a wierd looking wire. Take it off. Then pull off the wire. Then, take out the bulb. Remember to never touch the bulb. Hold it by the base only. The replacement bulbs are 9003. Then once you get the new one in do the directions above in reverse.
where does the yellow wire with a black stripe on it connect for dimmer lights,panel lights,and gear shift lights,for a 2000 Mitsubishi galant
No, there is no stock amp on a 2000 Galant
As of today, my 2000 Galant is at 130K.
need diagram of how to install pcm in a 2000 mitsbishi galant
A galant holds approximately 16 gallons.
It is important to know the firing order of a car being driven. The 2000 Mitsubishi Galant engine firing order is 1-3-4-2.
My car is 2000 Mitsubishi Galant 4cyl. 2.4L and it has 16.3galon gas tank. The fuel efficiency is 20 MPG city, and 27 MPG highway.
DISCONNECT THE BATTERY FOR A FEW MINUTES.
Engine running hot.
In the gas tank
yes it will be i got the 17 inch wheels for my 2003 galant and they fit like a glove.. not the OJ glove lol
The Vin numbers on a 2000 Mitsubishi Galant are located in two separate places. One is located on the drivers side door and the other is located on the top of the dash under the windshield.
Mitsubishi dealerships are the best places to find a Mitsubishi Galant. If one is looking for the 2000 model specifically then one should call ahead to see if they have one available. Another excellent place to look would be in the local newspapers.
nope the transmission shifts not the engine
one per valve
The firing order on a 2000 Mitsubishi Galant v6 3.0L is 1, 2, 3, 4, 5, 6. The number one cylinder is located closest to where the driver sits.
It's on the exhaust manifold right under your hood, at least it is in my 2000 Galant 2.4 L.
had the same problem on my 2000 galant. the bulb holder was not getting a good ground on the passenger side. i cut and wedged a piece of aluminum from a can between the bulb holder and where it fits into the light. both lights came on and worked fine. hope this helps.
It should be equipped with both.
serial # 9Z154277A (on top of stereo) your code is 6563