Whether you have the airbag or not, this involves removing the pockets/panels in the left/right side of your console. If you have an airbag it is more difficult for the right side, as you will have to remove a bracket (two 8mm screws) first. After this, it is a very painful learning experience the first time. The assembly is exactly the same as your lo-beams, however. So, look at the very helpful videos on YouTube for lo-beams. In fact, practice on a lo-beam. (A) Remove the wiring harness. (B) Remove the rubber boot which covers the assembly. (C) Push down on the spring-clip and swing the metal pressure harness out of the way. (D) Extract the bulb holder and bulb. (E) Remove the bulb harness adapter from the base of the bulb. (F) Reverse the process and put the new bulb in.... The hi-beams will be extremely difficult if you have large hands, you will have to do it almost entirely by feel - the assembly is tucked deep in the pocket and is hardly visible; and completely hidden as soon as you put your hand in there.
To change the high beam headlight on a 2008 Honda Goldwing you first have to remove the headlight housing by taking the six bolts off. After you remove the cover it is as simple as disconnecting the wiring and then pulling the light out.
The high beam may be blown. ---- Bad relay.
get a new light bulb ,take the cover off the light bulb that's broken and replace it.
on two door 08 accord H11 low beam and 9005 high beam 4 doors 9006 low and 9005 high
yes
you press that one button 5 times and it will do it automatically!!!! foo
I think you have to remove the front bumper to get full control to the bulb.
Burnt out or loosely connected bulb.
Cross Beam Racer
High beam-9005 Low beam-9006
You need to change the light bulb, the high and low beam on some vehicles are contained in a single bulb. or you could have a bad connection on just that one light
The 2006 Honda Pilot has 4 headlight bulbs - 2 low beam and 2 high beam. See sources and related links below.