There are several oil seals in most vehicles. We need to know which one and what vehicle. More info please.
Because high oil pressure is good...
In most model years, the high pressure oil pump is located under the intake manifold. Therefore, the first step is removing the intake manifold in order to access the pump. Undo the cover bolts and remove the high pressure oil pump, remove and discard all gaskets, seals and O rings. Replace the lower O ring seal, then the high pressure oil pump and bolts. Install the main oil pressure pump O ring seal, then the discharge pipe and bolts. Tighten all bolts to factory specifications. Install a new D ring seal on the discharge pipe and a new gasket on the oil pressure pump cover. Then replace the pressure pump cover and bolts.
how to change camshaft oil seal 95 pathfinder
check out www.powerstroke.org/forum/6-0 motor-problems/67527-high-pressure-oil-pump-04 high pressure oil pump 04 6.0 ford powerstroke diesel forum
What steps are needed to change a high pressure oil pump ona 03 6.0
Possible clogged oil galley, filter, defective oil pressure gage, or the use of an oil that is the incorrect weight. Replace the oil filter with a Purolator filter and change the oil. Install 5W-30 oil. If the pressure is still high then you need to have the oil pressure tested with an accurate test gage, to see exactly what it is.
Either pull the engine or the transmission. Before going to the trouble, check to see if replacing the seal will work out. Open the oil cap with the engine running. Place your hand over the hole and see if there is pressure (called blowby). If pressure is building inside the engine it will press on the oil seal and cause it to fail. Replacing an oil seal in an engine that has blowby is useless since it will fail again.
Oil pressure sending unit is located by oil pan in front. Unplug unscrew and install new one
Which oil seal and which engine?? There's an oil pan gasket, a rear main seal, a front seal, valve cover gaskets, and an oil pump shaft seal, just to name the main ones.
could be oil is low or in need of a oil and filter change. n0rt
How do you change rear main oil seal in a 2000 Toyota celica gt. thanks
put in a thicker oil if its the motor but if its trans. change oil and change the seal on the peace that you remove to take the oil out.