answersLogoWhite

0

To change the ignition lock on a 2002 Pontiac Aztek, start by disconnecting the negative battery cable for safety. Remove the steering column covers and then access the ignition switch by unscrewing it from the column. Use a key to turn the ignition to the "Accessory" position, which will allow you to press the release tab and remove the old lock cylinder. Finally, insert the new ignition lock cylinder, reassemble the steering column covers, and reconnect the battery.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Where is the abs fuse located on a 2002 Pontiac aztek?

fuse abs pontiac aztek 2002 located


How do you replace the thermostat on a 2002 Pontiac Aztek?

AnswerCould someone post directions on how to change the thermostat on a 2002 Pont. Aztek? Is it any different than a 2003?It shouldn't be any different....


Is there a fuel shut off switch on a Pontiac aztek?

Where is the fuel shut off on 2002 aztek


How do you replace ignition cylinder 2002 Pontiac aztek?

To replace the ignition cylinder on a 2002 Pontiac Aztek, first, disconnect the negative battery terminal to ensure safety. Then, remove the steering column cover by unscrewing the screws and gently prying it apart. Insert the key into the ignition and turn it to the "Run" position, allowing you to press the release pin on the ignition cylinder. Finally, pull out the old ignition cylinder and insert the new one, ensuring it locks into place before reassembling the steering column cover.


How do you reset the security code on a 2002 Pontiac Aztek?

To reset the security code on a 2002 Pontiac Aztek, first, disconnect the vehicle's battery for about 10 minutes to reset the system. Reconnect the battery, then turn the ignition to the "On" position without starting the engine. Wait for about 10 minutes until the security light turns off, then turn off the ignition and restart the vehicle. If you have the original key, it may also help to use it to start the engine after the reset.


How big is the fuel tank on a 2002 Pontiac aztek?

The fuel tank on a 2002 Pontiac Aztek has a capacity of approximately 16 gallons. This allows for a reasonable driving range between fill-ups, depending on driving conditions and fuel efficiency.


How do you change the shift solenoid in a 2002 Pontiac aztek?

To change the shift solenoid in a 2002 Pontiac Aztek, first disconnect the negative battery cable to ensure safety. Then, remove the transmission pan and fluid to access the solenoid. Locate the shift solenoid, disconnect its electrical connector, and unbolt it from the transmission. Replace it with the new solenoid, reassemble the transmission pan, refill the fluid, and reconnect the battery.


Replace tumbler ignition in 2002 Pontiac Aztec?

To replace the tumbler ignition in a 2002 Pontiac Aztek, start by disconnecting the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the screws, then locate the ignition lock cylinder. Insert the key and turn it to the "Run" position while pressing the release tab to pull out the tumbler. Finally, install the new ignition tumbler by reversing the steps, ensuring everything is securely reassembled.


How many quarts of oil does a 2002 Pontiac Aztec hold?

The Aztek holds 5 qts of oil


Where is oil filter located on 2002 Pontiac aztek?

On a 2002 Pontiac Aztek, the oil filter is located on the engine, typically near the oil pan. It is mounted on the side of the engine block, making it accessible from under the vehicle. You may need to remove some components or use a wrench to reach it easily. Always ensure the engine is cool before attempting to change the oil filter.


How do you change blinker bulbs on 2002 Pontiac Aztek?

To change the blinker bulbs on a 2002 Pontiac Aztek, first, open the rear hatch and locate the tail light assembly. Remove the screws or fasteners holding the assembly in place, then carefully pull it out. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble by reversing the steps. Ensure the new bulb is securely in place before testing the blinker.


How do you a change a battery in a 2002 Pontiac Montana?

how do you change a battery on a 2002 Pontiac Montana