0
Its located on the drivers side engine compartment towards the firewall just under the hood hinge. You need a special socket to remove it from the heat sink. Remove from the heat sink remove the plug and replace.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
1983 ford bronco wont get spark from the coil any help please?
check the ignition control module.
1991 Ford Bronco with a 5.3 liter engine When the ignition switch is turned to on and the 'coil wire' is off of the ignition module the coil module contact arcs continually Bad Module?
you don't have a 5.3L in the bronco. If it is indeed an Eddie Bauer then it should be a 5.8L, but other options include 5.0L and 4.9L.
What is tfi module on ford bronco 2 2.9 v6?
Thick film IV ignition system. Attached to the outside of distributor
You can go about 40 miles in your ford bronco II then it will die?
When mine was doing that, it was the ignition module. Does it start back up after sitting for awhile?
What causes ignition control module to fail repeatedly in 1991 Ford Bronco 302 FI?
http://www.therangerstation.com/tech_library/TFI_Diagnostic.html Heat
Where is the ignition module located on a 1990 Ford Bronco with a 5.8L engine?
there might two one is under the dash and the other is on the distruber(sp)
Where can you find an early bronco ignition diagram?
1984 ford bronco
Where is the ignition module located on a 1989 ford ranger?
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Where is the location of the ignition control module on a Ford Focus?
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
Where is the ignition control module on a 1988 ford bronco 2?
Most likely it is the TFI module mounted on the back side of the distributor. Takes a special tool to remove it, available at auto zone for about 5 bucks.
Where is the ignition module located on a 1986 ford bronco?
On the back of the distributor which is located on the top of the engine rear center, the ignition module (or TFI module as ford calls it) has two screws bolting it to the distributor and one electrical connection, when you replace this you MUST use di-electric grease when installing the new one or it will fail due to excessive heat created by the engine.
Where is the dura spark ignition module located on a 1991 Ford probe?
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
