The ignition switch on a 1995 Mazda pickup is changed by partially removing the steering column to reveal the switch on the side of the column. It can then be unbolted from its mounts, the wires disconnected, and a new switch put in place.
by the steering wheel
immobilizer is in the key and pickup ring on the ignition lock
How to remove ignition switch on a 91 Mazda Navajo
Color coded instructions on how the wiring should go in my pickup truck ignition
can some one tell me if you can change the gasket on the back of the injection pump on 1983 mazda diesel pickup with out any problems
2002 mazda ,,gauges are still working after taking out key..any ideas
switch is either on side of transmission, or under the dash
How do I adjust a stoplight switch on my mazda 626 LX V6
On a 1981 MAZDA 626 (same engine)2.0 you remove the right/left cover on the steering column (three screws) and remove them. On the left side behind the key cylinder is the disc (round) ignition switch with several wires attached in a circular pattern around it. Wires and connectors (believe 4) go down the steering column from it (this is the ignition switch). The part # is Niehoff LC62411 on my 626. You remove this and install the new part in it's place. Problem is finding the part. Get one from a junkyard if nothing else. Also, the 82 Mazda truck is the same as an 82 Ford Courier (so maybe a Ford dealer has the part). Ford owns about 30% of Mazda and a Ford VP runs it.
It could be the ICM or the pickup module.
4qts
MOST OF THE TIME IT IS 6"DEGREES Before Top Dead Center with hose connected