The lamp on a Hitachi 52 inch television is changed by opening the rear cover of the TV and removing the bulb cover. The bulb is then unlatched, pulled from its socket, and a new bulb installed.
PT-43LC14/PT-50LC14/PT-60LC14.
1) Make sure the TV is on.
2) While pressing and holding down VOL DOWN button on the TV, press and hold down SPLIT PLAY button on the remote until a message appears on the screen that the lamp timer has been reset. NOTE: You must hold the buttons down at least 5 seconds - look for the the "Lamp timer has been reset to zero" screen.
The projection lamp, from the sound of things.
That sounds like a Hitachi model number. ON the front, to the left hand side should be a panel that you can remove to obtain access to the lamp. Most likely it'll be embossed with the word, `LAMP'.
Average lamp expectancy is about 2000 hours. If the TV shuts off the lamp intermittantly and then powers back on after a minute or so, a lamp change is probably in order.
The cost of a replacement lamp for a Hitachi UX21511 would vary by retailer. One would expect to pay an average of about $50 from most online sellers.
Your owners manual will describe the procedure.
The price for a Hitachi Lamp seems to vary greatly depending on the model and design of the lamp itself. Some of the more expensive models retail for around 200 dollars, while cheaper ones only cost thirty. The average seems to be somewhere in the seventy dollar range.
The lamp is a piece of equipment that is built into your LCD TV. This lamp is what brightens the screen on the television. The bulbs for this lamp can break and need to be replaced.
A Sony kdf s55a20 is a 55 inch LCD rear projection lamp for a Television a normal retail price is around 66 dollars , http://www.amazon.com/Sony-KDF-E55A20-55-Inch-Projection-Television/dp/B0009Y2EXI
blood lamp television
The lamp must be adjusted.
Hitachi projector lamps can be purchased at several electronics stores. New Egg, Mwave, Sears, and Projector Central all have these lamps for sale online.
A Panasonic TV lamp is for projection televisions that have burnt out their bulb already. If you need to replace your TV lamp then you will have to probably get someone to do it for you unless you are comfortable with your technology abilities.