E60? can be done with the headlight in the car, is a pain in the A!! remove round cover on back of lamp. The corrona light bulb socket/holder is shiny brown. 1/3 turn removes it. Putting in is the hard part, usually can only use 2 fingers to put in and turn. I have had some better success with hose removal needle nose pliers.
The headlight bulbs for the Chrysler LHS are inserted in the back of the light housings. There is a twist ring that holds them in, rotate the ring to remove and replace the bulb.
Open the hood of the Montana and fid the turn signal assembly. Dislodge the assembly from the car and wiggle the black retainer ring so that you can pull the bulb free by the blue tabs. Insert the new bulb and press firmly into retaining ring, reassemble.
Remove the instrument panel cover. Remove the light bulb retaining ring. Remove the light connector. Reverse the process to install the new light bulb.
Remove the shifting console cover. Remove the shifting light retaining ring. Push the light bulb in and turn at the same time. The light bulb will come out. Reverse the process install the new light bulb.
There's a plastic ring around the bulb you can remove and then twist out the base holding the bulb. Then change the bulb and twist it back in followed by the retainer ring. It's really simple (for a change). The rear spark plugs are a different story.
Pop Hood. Remove black retaining ring that holds light bulb socket in the light housing. This requires turning the ring and then pulling the socket out. Exchange bulbs and replace as removed. .
Glass is the insulator in a light bulb. The base has a heavy piece of glass to separate the ring from the center, and there is a glass support inside the bulb to hold up the filament and separate the wires going to the filament.
Pull off the head light bezel,4 screws,then the head light ring also 4 screws.pull out bulb unplug and then reverse operation
Reach behind the housing and you will find a bulb capsule with a retaining ring (plastic). Turn the plastic ring to the left (lefty loosie). After ring comes off, you pull out the capsule (with o ring).
Inside the bonnet at the rear of the indicator light fitting is a steel ring. This is a clip-in spring fitting. Once unclipped the indicator unit slides out. The bulb is attached by a simple push on fitting.
It's very simple to replace the head lamp bulbs. Simply loose the outer ring wich keeps the bulb in site, remove the cable harness, pull the bad bulb out, get a new bulb and insert it back into the light assembly, tighten the outer ring, replace the cable harness and you're done...It will take no longer than 10 minutes per side,
remove plastick cover at back of lightunhook the electricity at the back endunscrew the plastic ring (about 2" diameter) off the backthis ring holds the bulb in placefrom water side, remove the build (centre spindle bit)some force will be required since the build has an O ring on the back end and it will need a good pull that's it.