The Head lamp bulbs un-screw from the rear of the assembly. TIP: do not touch the new bulbs the oils from your fingers will blow the bulb. If you must touch the glass use latex gloves or clean them with rubbing alcohol prior to instalation...Good Luck
To change the dash light bulbs you must remove the instrument panel.
There is one screw that holds the fog light it into place.Unscrew that screw and the fog light will pull out of the bumper.
Not sure on the 89 Geo Tracker but on most newer vehicles the tail light bulbs can be accessed by openening the rear door and removing a panel that allows access to the tail lights if this is not possible you should have some type of screws on the tail light lenses itself that can be removed to access the bulbs. , EzForJesus my 91 Tracker 2 door had 2 small screws at the bottom of the tail light - I had to push the rubber fascia down slightly to get a Phillips screwdriver into the screws. Remove both screws, tip the bottom of the fixture out and you now have access to the 1/4-turn twist-out bulb holders. Change bulb(s) and reverse procedure. Cass1959
Who to Change engine check light bulbs on a 1996 BMW 318i?
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
Not enough info - WHAT bulbs?
HOW DO I CHANGE LIGHT BULBS
= Answer = you dont
turn the bulb clockwise until it pops out unclip it put in new one and twist it back in tadaaaaa!
What is the part number for the 2008 HHR tail light bulbs and backup light bulbs?
In recent years, the light bulb started to change when the newer CFL bulbs came out. The newer bulbs were energy efficient and people were urged to change older incandescent bulbs to the newer ones.
Both the lens and the light pull out.