0
How do you change lower control arm bushings on a 2005 Pontiac Montana?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you a change a battery in a 2002 Pontiac Montana?
how do you change a battery on a 2002 Pontiac Montana
How do you change freeze plugs in Pontiac Montana?
where is the freeze plug located in a 2000 pontiac montana mini van
How do you change Saturn Ion Control Arm Bushings?
go to a mechanic
Can you change your lower control arm bushings on your 2002 Lincoln ls?
Yes!
Why does 2002 Pontiac Montana overheat?
one issue could be that you need to change your thermostat
How do you change the brake master cylinder on a 2002 Pontiac Montana?
how to change the master cylinder without taking it to a shop
Do 2007 Pontiac G5 have grease fittings?
The G5 doesn’t come from the factory with grease fittings but that doesn’t mean that yours doesn’t, a lot of people will change there old worn bushings with new bushings that have grease fittings!
How do you change rear spark plugs in 2003 Pontiac Montana?
Jack up vehicle and change the rear plugs from underneath!
How do you change a radiator on a 2001 Pontiac Montana?
Before changing the radiator on a 2001 Pontiac Montana the coolant must first be drained. After the drain remove the radiator mounts, fans, and hoses. Pull the radiator upwards.
How do you change front turn signal on 2006 Pontiac Montana?
You can change the front turn signal, on your 2006 Pontiac Montana, by removing the retaining nuts. Remove the wiring harness. The turn signal will come free. Reverse the process to install the new turn signal.
Change sparkplugs Pontiac Montana?
The rear plugs have to be done from below. I took mine to the dealer and it was $150 to change the 3 plugs.
How do you replace front control arm bushing in 2002 Bonneville?
The control arm bushings are pressed into the control arm. You must use a press (ball joint press with proper adapters, etc.) to remove and install bushings. You may need to heat old bushings with torch to remove bushings from control arm. If you are comfortable with this then here is what you need to do: Remove wheel. Use safety glasses while removing ball joint stud from steering knuckle. Unbolt control arm from vehicle. Change bushings. Install control arm in reverse order. You should get an alignment after doing any front end work.
