Caution: The sensors use a pigtail and connector. This pigtail should not be removed from the sensor. Damage or removal of the pigtail or connector could affect proper operation of the oxygen sensor. Keep the electrical connector and louvered end of the sensor clean and free of grease. NEVER use cleaning solvents of any type on the sensor! The sensor may be difficult to remove when the engine temperature is below 120°F (48°C). Excessive removal force may damage the threads in the exhaust manifold or pipe; follow the removal procedure carefully
1. Make sure the ignition is OFF, then disconnect the negative battery cable.
2. Locate the oxygen sensor. It protrudes from the exhaust manifold or exhaust pipe (it looks somewhat like a spark plug). It may be necessary to raise and safely support the vehicle to access the sensor.
3. Unplug the sensor electrical connector.
Note: There are special wrenches, either socket or open-end available from reputable retail outlets for removing the oxygen sensor. These tools make the job much easier and often prevent unnecessary damage.
4. Carefully unscrew the sensor, then remove the oxygen sensor from the manifold or pipe.
To install:
1. During and after the removal, be very careful to protect the tip of the sensor if it is to be reused. Do not let it to come in contact with fluids or dirt. Do not clean it or wash it.
2. Apply a coat of anti-seize compound to the bolt threads but DO NOT allow any to get on the tip of the sensor.
3. Install the sensor in the manifold or exhaust pipe.
4. Attach the electrical connector and ensure a clean, tight connection.
5. If raised, carefully lower the vehicle.
6. Connect the negative battery cable.
The 2000 Acura Integra OBD 2 port is under passenger dash
No
Driver side if intake manifold last cyl. up on top
The headlight assembly on a 2000 Acura Integra is held on using bracket bolts. Prop the hood open and locate the headlights. Unbolt the brackets and remove them. Carefully pry the headlight assembly out to not harm the weatherstripping.
No where. does not have one.
where is the ignition module located ina 2000 integra acura
There is a sensor in the top of the brake cylinder where you put in the fluid. Replace it and the light will go away.
yes, if you have the correct harness for the module for that setup.
Yes, but you'll need to change the headlights to 1998-2001 models.
call a mechanic they know how.
right next to the fuse box
The 2000 Acura Integra dashboard speakers measure 3.5 inches in diameter. The front door speakers measure 5.5 inches in diameter. The rear speakers measure 7.5 inches in diameter.