you have to take all the plastic trim off inside the rear around the window the window is bolted into place yes i know it sounds crazy but there little nuts tend bolts are molded into the rubber around the window and nuts on the inside so there you go
yes
To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.
It's about this wide and about yay so tall...
check any bronco group web site, membership is usually free and they have all the schematics for the back window wiring and more
Try Wd 40 in the left and right guides
If its the bronco XLT you'll have to take the tail gate paneling off the inside. The motor, gears, etc. for the rear window are located in there. I had the same problem with mine sometime back.
break it
Sure, turn it sideways and push it in the back hatch
my 81 takes 6L did it 2 day it has 302
Full back soft tops for the Ford Bronco can be found on BroncoGraveYard.com.
Underneath, back of engine, passenger side.
If it's manual, either the handle is broken, the window regulator is stripped, or the glass is broken and missing. If it's electric, either the switch is bad or the lift motor is bad. Or the glass is missing.