1. Remove cover from top of the motor (depending on the motor the recoil is attached to it) should have three bolts. When the cover is off you will see a fly wheel with a recoil clutch (or just a nut if the recoil is not on top). Take a pry bar or large screw driver jam the fly wheel with it (make sure you do not damage it). Use a pipe wrench or gently tap the recoil clutch loose with a hammer. Then take two pry bars and pry on the bottom edge of the fly wheel ( be carefull where you pry find two solid spots on the case)the fly wheel should pop off if not keep the pry bars prying and get a piece of wood and tap the end of the nut shaft this should knock it loose. Now you should be able to see the points and condenser. Take the screw off the pivot point on the points and take the bracket off the condenser. Once you put the points and condenser back in put the points at the open position - make sure the condenser is not tightened - put a piece of cardboard (about the thickness of a cigarette pack) between the points and gently push the condenser until it just touches the cardboard and tighten the condenser bolt. Then put it all back together again.
craftsman
One can purchase parts for a used Briggs and Stratton lawn mower from the following sources: Mower Graveyard, eBay, Briggs and Stratton, Zangler Repair, Lowes, Discount Online Parts.
you can goto briggsandstratton.com and get a manual for that engine,
Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?
0.030 is the gap for briggs and stratton 4.5 hp mower
Briggs and Stratton does contract anyone to build mowers. The mower manufacturers contract Briggs and Stratton to build their engines (or whatever engine is on the unit). That is why you can have a Briggs and Stratton on most any type of mower. Same is true for Kohler, Tecumseh, etc. Not to say that the engine manufacturers do not build their own type of outdoor power tool but as the question states "snapper mower". Also keep in mind that if you have a snapper mower with a Briggs and Stratton engine and you need warranty work on the engine you need to go to an Authorized Briggs repair facility where as if you have a mower warranty then you need to go to an authorized repair facility for the mower manufacturer.
On the bottom of the mower, it takes 3/8" socket driver (no socket) to remove it
Briggs and Stratton and Kohler engines are considered quality components. Neither is likely to be better. However, the Briggs and Stratton brand is more popular.
You can find the operator's manual for that engine at www.briggsandstratton.com. You will need to contact the manufacturer of the mower for the lawn mower owner's manual. Briggs and Stratton did not amke that mower, only the engine.
sae30
It is a 2-cycle 4HP Briggs motor.
Briggs and Stratton is a select brand of lawn mower. When oiling one's Briggs and Stratton lawn mower engine, it is best to use a high quality oil. One can find such an oil at their local home improvement store, such as Home Depot.