0
Support the car on jack stands.you should spray all bolts with PB Blast it will help losen bolts easer.Then you use a spring compressor tool.As you tighten the bolts it collapses the spring.You can also use a torch to weaken the springs.Be very careful the spring is under tension it can jump out and injure you.Losen and remove bolts.Replace new springs.You can use a car jack to put pressure on the springs during instillation you take your time its easy be careful not to hit brake lines or outher delicates. Good Luck
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Does a 72 Nova rear end fit a 73 nova?
Yes, this should be a perfect fit.
What rear seat will fit a 1970 Chevy Nova?
Any rear seat out of 1968-72 Nova's, no the camaro rear seat will not fit they are different sizes. Just throw that in there because most people think because the two cars share major components that these also are interchangeable when they are not.
How do you convert 73 nova rear tail light panel rear bumper and gas tank to 72?
Replace the stock tail panel with a 68 thru 72 panel.Next swap gas tanks the 73 neck faces up above the bumper not downward like the 68 thru 72.The final step install a 68/72 rear bumper to finish it off.
What are the differences between 68-72 Chevy Nova?
Available engine packages, and Chevy did away with the 12 bolt rear end in 71.
Will 72 nova bumpers fit on 68 nova?
Yes
Will a 72 nova front clip fit a 73 nova?
Yes it will bolt right on
What is the color of the wire under the hood for the heater blower motor for a 72 Chevy Nova?
On my 72 nova the wire going to the blower looks to be purple.
Can you make 72 nova headlight bezels work on a 73 nova?
Perhaps with some modification
Are the front bumper brackets from a 72 chevy nova the same as a 73 chevy nova?
Yes, they are.
Will 72 nova grill fit on a 74 nova?
No, they're 2 totally different grilles
Will 74 nova bench seats fit in a 72 nova?
It should fit as there the same body .
What is involved in replacing rear wheel bearings in 72 Nova?
you have to pull the axle completely out of the rearend and the bearing is on the axle and you have to press it off the axle to get it off and press the new one on.
