The Switch can be removed by gently prying under the switch flange with a small flat head screw driver. Take care not to damage the door panel. The switch should pop out fairly easily. The door panel does not need to be removed. The swith can then be separated from the wiring harness be simply depressing the orange tab on the harness socket. Plug the new switch into the harness and reinsert the switch into the top of the door panel.
no
Remove the inside door panel of your 1997 Mercury Cougar. Remove the wiring harness from the window motor. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
Put a brick through the window.
Remove the inside door panel of your 1999 Mercury cougar. The entire window mechanism will be visible. Remove the wiring harness from the window motor. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install your new window motor.
It's held on by one screw in the hand hold.
The yellow with green wire goes from the switch to the relay which is to the right of the speaker and then from the replay it changes to yellow and goes to the motor.
get a pocket knife or something sharp and pry up on switch, it just pops up then unplug wire and replace switch then push down to reinstall switch very simple as I just put in 2 of them in less than 5 mins.
If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.
ow do I access window switch on a 99 mercury willager?
I would remove the door panel and have a look at what's going on in there the window has obviously popped out of the guide.
The 1998 Mercury power window relay switch can be found below the dashboard. The relay switch will be on the drivers side of the dashboard.
Check to see if you are getting power to the motor if so window motor is defective Could be open wire usually in the door jamb area